Chapter 7 Menu System
Chapter 7 Menu System 7-25
7-4 Disk File Management Menu
7-4-1 Items in the Disk File Management Menu
The disk file management menu contains the following
items.
In the “Settings” column of the table, the factory
default settings are indicated by an enclosing box.
Item number Item name
Settings
F1 SELECT RECORD TYPE For recording and editing using the hard disk, select full edit mode or simple edit
mode.
FULL : Full edit mode.
SIMPLE: Simple edit mode.
Note
Make this setting before carrying out any file creation. If there are already any
recorded files, it is not possible to change this setting.
F2 CONVERT TYPE
(S ˜ F)
Set this to ON to convert the type of files recorded on the hard disk (conversion
between files recorded in full edit mode and files recorded in simple edit mode).
Note
The conversion from a file recorded in simple edit mode to the full edit mode
format takes a total of between 1/2 and 1/3 of the time required to record the
original file.
F3 SELECT GOP/FRAME For a program created in simple edit mode (when F1 is SIMPLE), select the
editing accuracy (GOP: ±1 frame; FRAME: ±0 frame).
GOP: Carry out editing in GOP
a)
units. The editing accuracy is ±1 frame.
FRAME: Carry out editing in frame units. The editing accuracy is ±0 frame.
F4 DELETE PROGRAM Set this to ON to delete the program from the hard disk (DISK PROGRAM).
Files in DISK MASTER are not deleted.
F5 DELETE ALL FILE Set this to ON to delete the program and all files from the hard disk (DISK
PROGRAM and DISK MASTER).
a) GOP: abbreviation of “Group Of Pictures”. This is the
number of frames in the unit for carrying out video data
compression. For Betacam SX, video data is compressed
taking two frames as a unit.
To Next Page
Loading...
Need help?
General
