5-12 Chapter 5 Editing Using the Built-in Hard Disk
Chapter 5 Editing Using the Built-in Hard Disk
5-2 Basic Editing Operations
Note
When MASTER or PROGRAM is specified as the
player and PROGRAM is specified as the recorder,
executing the automatic editing with the recorder OUT
point set causes the program information to be saved to
the hard disk and no image to be output to the monitor.
As a result, it is not possible to abort the editing
operation. It is, however, possible to undo the effect of
the editing operation after it has completed. (See the
next section 5-2-11, “Undoing an Editing
Operation.”)
Reviewing the editing results
After carrying out an editing operation, you can carry
out a review, to check the editing results on the
monitor.
To carry out a review, press the PREVIEW/REVIEW
button after carrying out the edit and before you set
any new edit points or make other settings.
The PREVIEW/REVIEW button lights, and the review
is carried out.
At the end of the review the PREVIEW/REVIEW
button goes off, and the recorder returns to the OUT
point.
To adjust the edit points and reexecute the
edit after automatic editing
Hold down the RECALL button or DELETE button,
and press the ENTRY button to recall the edit points.
After adjusting the edit points, press the AUTO EDIT
button to carry out the edit again.
Note
When PROGRAM is specified as the recorder, and the
EDITING MODE button is set to INS, the event
pertaining to an automatic editing operation is inserted
at the recorder IN point. An event already present at
the recorder IN point is not overwritten, but slides
forward.
For details of how to adjust edit points, see Section 5-2-7,
“Modifying and Deleting Edit Points” (page 5-8).
5-2-11 Undoing an Editing
Operation
When PROGRAM is specified as the recorder, you can
use the following procedure to undo the effect of the
immediately previous automatic editing operation.
1 Immediately after the automatic editing operation
has completed, press the UNDO button, turning it
on.
The AUTO EDIT button flashes.
2 Press the AUTO EDIT button.
This undoes the effect of the immediately previous
automatic editing operation, and the UNDO button
goes off.
Aborting the undo operation before carrying
out step 2
Press the UNDO button again, turning it off.
This returns to the state before you carried out step 1.
12
To Next Page
Loading...
Need help?
General
