Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing) 6-7
6-1-7 Carrying Out Automatic Editing
Overview
When you carry out automatic editing, the recorder
and player operate as shown in the following figure, to
copy the video and audio signals between the IN and
OUT points on the player to the segment between the
IN and OUT points on the recorder.
Monitor output
During execution of an automatic edit, you can
monitor the playback video on a monitor connected to
the recorder. The type of video depends on the current
settings.
For details, see the table “Monitor output video during
previews and editing” in Section 5-2-9 “Preview”, referring
to the case when the player is EXT and the recorder is
TAPE.
Tape transport
Time flow
Preroll point
IN point
OUT point
Postroll point
Recorder
Preroll
Assemble editing
Postroll
Recording
overlap
Stop
Player
Playback
Stop
To Next Page
Need help?
General
