Connecting
to
the
AC
power
source
To use your Printer abroad -
Power sources
You can use your Printer and the AC Adaptor
(supplied) in any country or region where the
power supply is within 100 V
to
240 V AC,
50/60 Hz.
Do not use an electronics transformer (travel
converter), as this may cause a malfunction.
/
//
.,
.....
,.
/;/'
1
"~T
/ AC adaptor
10cm
(13/32
inches)
• Do not place the printer
in
an unstable location
such
as
on a wobbly table.
• Leave enough room around the printer. The print
paper emerges from the back a few times during
printing. Keep
10
em (13/32 inches)
or
more space
at the rear
of
the printer.
• Connect the AC adaptor to an easily accessible
wall outlet close by.
If
trouble occurs while using
the adaptor, immediately shut
off
the power by
disconnecting the plug from the wall outlet.
• Do not short the plug
of
the AC adaptor with a
metallic object, as this may cause a malfunction.
• Do not use the AC adaptor placed
in
a narrow
space, such as between a wall and furniture.
• When you have finished using the AC adaptor,
disconnect the AC power cord from the
DC IN 24 V jack
of
the printer and from the AC
power sources.
• The printer is not disconnected from the AC power
source (mains) as long as
it
is
connected to the wall
outlet, even if the printer itself has been turned off.
• A socketoutlet should be
as
close
as
possible to the
unit and easily accessible.
-
1 Insert the plug of the AC adaptor
into the DC
IN
24 V jack on the back
of the printer.
2 Connect one plug of the AC power
cord to the connector of the AC
adaptor and the other plug to the
wall outlet.
To Next Page
Loading...
Need help?
General
