11
Location and Functions of Parts and Controls
Overview
A CAMERA SELECT buttons
Press the button corresponding to the
camera you want to operate with the
infrared remote commander.
The camera number can be set using the
IR SELECT switch on the rear of the
camera.
If two or more cameras are adjacent and
have the same camera number, they are
operated simultaneously with the same
infrared remote commander. When you
install the cameras close to each other,
set different camera numbers.
For the camera number setting, see
“Operating Multiple Cameras with the
Infrared Remote Commander”
(page 23).
B FOCUS buttons
Used for focus adjustment.
Press the AUTO button to adjust the
focus automatically. To adjust the focus
manually, press the MANUAL button,
and adjust it with the FAR and NEAR
buttons.
Press the MANUAL button and adjust
the focus manually when shooting the
following objects.
• White walls and other objects without
contrast
• Objects behind glass
• Objects with horizontal stripes
• Objects on which bright lights are cast
or reflected
• Nightscapes and other dark objects
with blinking lights
• Lit objects shot with darkened
exposure adjustment or exposure
compensation settings
C DATA SCREEN button
Press this button to display the main
menu. Press it again to turn off the menu.
If you press the button when a lower-
level menu is selected, the display goes
back to a higher-level menu.
Pan/tilt operations are disabled when the
menu is displayed (except PAN/TILT
LIMIT setting).
D PAN-TILT buttons
Press the arrow buttons to adjust the
direction of the camera. Press the HOME
button to face the camera back to the front.
When the menu is displayed, use V or v
to select the menu items and B or b to
change the set values. The selected
setting menu is displayed, by pressing
the HOME button when the main menu
is displayed.
E L/R DIRECTION SET button
Hold down this button and press the REV
button to change the direction of the
camera movement opposite to that
indicated by the arrow of the
B
/
b
buttons.
To reset the direction of the camera
movement, press the STD button while
holding down this button.
Infrared Remote Commander
(supplied)
Note
Note
Note
To Next Page
Loading...
Need help?
General
