22 Pan/Tilt and Zoom Operation
To face the camera toward the
opposite direction
You might wish to face the camera toward
the opposite direction from that of the button
you pressed, for example, when you change
the direction of the camera while checking
the picture on the screen. In such a case,
press the 2 (REV) button while holding
down the L/R DIRECTION SET button.
To reset the setting
To reset the setting, press the 1 (STD) button
while holding down the L/R DIRECTION
SET button.
The setting above only changes the signal
emitted from the infrared remote
commander, and does not change the setting
of the camera itself. Therefore, repeat the
setting for each infrared remote commander
if you are using more than one infrared
remote commander.
When the STANDBY lamp is blinking
If the camera is moved forcibly, or a finger
or other object interferes with camera
movement, the camera may fail to memorize
the pan/tilt position.
Press the PAN-TILT RESET button to reset
the pan/tilt position.
Press either of the ZOOM buttons.
When you perform pan/tilt operation while
the camera is in the telephoto mode, the
moving speed of the image on the screen
may be a little jerky.
Arrow
button
Movement of
the camera
Setting
Arrow
button
Movement of
the camera
Setting
Note
While
holding down
Press
While
holding down
Press
Zooming
Note
The STANDBY lamp blinks.
Subject appears
farther away.
(Wide angle)
Subject appears
closer. (Telephoto)
Zooms in or out
fast (FAST side)
Zooms in or out
slowly (SLOW side)
To Next Page
Loading...
Need help?
General
