30 Message List
B Appendix
Message List
The following messages and indications may appear for this camera. Perform the following as
necessary.
Lamp display
Screen display
Lamp Meaning and solution
The STANDBY lamp and
POWER lamp are lit.
The SYSTEM SELECT switch is set to “no output” (page 9).
The STANDBY lamp is lit. If the camera is moved forcibly, or a finger or other object interferes
with camera movement, the camera’s built-in processor may fail to
memorize the pan/tilt position.
Press the PAN-TILT RESET button to reset the pan/tilt position.
Message Meaning and solution
PRESET n:OK
(“n” is a preset position
number between 1 and 16)
This message appears for about 3 seconds when you store camera
settings to POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
RECALL n:OK
(“n” is a preset position
number between 1 and 16)
This message appears for about 3 seconds when you read the camera
settings stored in POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
RESET n:OK
(“n” is a reset position
number between 1 and 16)
This message appears for about 3 seconds when you reset camera
settings stored in POSITION 1 to 16.
The preset position number of the infrared remote commander is
POSITION 1 to 6.
ONE PUSH WB:OP During the white balance adjustment in the ONE PUSH white
balance mode, this message blinks on the screen.
ONE PUSH WB:OK When the white balance adjustment has been done correctly in the
ONE PUSH white balance mode, this message is lit on the screen.
ONE PUSH WB:NG When the white balance adjustment has failed in the ONE PUSH
white balance mode, this message blinks on the screen.
To Next Page
Loading...
