20 Before Operating / Turning on the Power
B Operation Using the Supplied Infrared Remote Commander
Before Operating
Before operating the camera, check that the
camera and peripheral devices are properly
installed and connected.
For details, see “Setting of the SYSTEM
SELECT switch” (page 9), “Installing the
Camera” (page 26) and “Connections”
(page 27).
The supplied infrared remote commander
may not work correctly near the inverter
lighting fixtures. In such a case, try to install
the camera far from the inverted luminaire.
You can check whether or not the installed
location is good for the usage of the infrared
remote commander.
For detailed information on how to check,
refer to the Technical Manual. For details
on obtaining a Technical Manual, consult
your Sony dealer.
Turning on the
Power
1 Connect the camera to an AC outlet
using the supplied AC power adaptor
and power cord.
The power is turned on and the POWER
lamp lights.
The camera will automatically pan and
tilt and be reset to the position stored in
POSITION 1 (Pan/tilt reset action).
2 Turn on the peripheral devices.
Note
POWER lights.
to AC outlet
DC 12 V
SRG-120DH
To Next Page
Loading...
Need help?
General
