103
GB
Using Other Features
Switching the command
mode of the receiver and
the remote
You can switch the command mode
(COMMAND MODE AV 1 or COMMAND
MODE AV 2) of the receiver and the remote.
Switch the command mode from the initial
setting to the appropriate setting, if other Sony
component is operated accidentally by the
same remote, when you are operating the
receiver using the remote supplied with the
receiver.
The command modes of both the receiver and
the remote are those of the initial setting
(COMMAND MODE AV 2).
The receiver and the remote, on the contrary,
should use the same command mode. If the
command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
1 Press ?/1 to turn off the
receiver.
2 While holding down 2CH/
A.DIRECT, press ?/1 to turn on
the receiver.
When the command mode is set to “AV2,”
“C. MODE AV2” appears on the display.
When the command mode is set to “AV1,”
“C. MODE AV1” appears on the display.
Press MUTING and at the same
time while pressing DISPLAY.
1 Press ?/1 while pressing RM
SET UP.
The AMP and ZONE buttons flash.
Switching the command mode of
the receiver
2CH/A.DIRECT?/1
Switching the command mode of
the simple remote commander
Switching the command mode of
the multifunction remote
commander
DISPLAY
MUTING
ZONE
?/1
AMP
ENTER
1, 2
RM SET
UP
SHIFT
continued
To Next Page
Loading...
Need help?
General