Sony STR-DA3600ES User Manual

47
GB
Getting Started
On setting up the active
subwoofer
• When a subwoofer is connected, turn on the
subwoofer and turn up the volume
beforehand. Turn the LEVEL knob to just
before the mid-point.
• If you connect a subwoofer with the
crossover frequency function, set the value
to maximum.
• If you connect a subwoofer with an auto
standby function, set it to off (deactivated).
Note
Depending on the characteristics of the subwoofer
you are using, the setup distance value may be
further away from the actual position.
To use the receiver as a pre-
amplifier
You can use the auto calibration function when
you use the receiver as a pre-amplifier.
In this case, the distance value shown on the
display may differ from the actual distance
value. However, there will be no problems,
even if you continue to use the receiver with
that value.
The auto calibration function allows you to
measure the following:
• Speaker connections
1)
• Polarity of speakers
• Speaker distance
2)
• Speaker size
2)
• Speaker level
• Frequency characteristics (EQ)
2) 3)
• Frequency characteristics (Phase)
2) 4)
1)
The measurement result is not utilized when the
multi-channel input is selected.
2)
The measurement result is not utilized in the
following cases.
– The multi-channel input is selected.
– “2ch Analog Direct” is being used.
3)
The measurement result is not utilized when
Dolby TrueHD, or Linear PCM signals with a
sampling frequency of 176.4 kHz and higher are
being received.
4)
The measurement result is not utilized when
signals with a sampling frequency of 88.2 kHz and
higher are being received.
1 Press MENU.
The menu is displayed on the TV screen.
2 Press V/v repeatedly to select
“ Settings,” then press or
b.
The Settings menu list appears on the TV
screen.
Performing auto calibration
V/v/B/b,
MENU
RETURN/
EXIT O
continued

Sony STR-DA3600ES Specifications

General

Brand	Sony
Model	STR-DA3600ES
Category	Receiver
Language	English