93
GB
Using Multi-zone Features
Tip
When you set this item to “VARIABLE,” the volume
for the ZONE 2 AUDIO OUT and the ZONE 2
SPEAKERS terminals can be changed in
conjunction with each other.
Switching the zone
setting of the remote
The remote commander is initially set to be
used in zone 2. If you want to use it in zone 3,
switch the zone setting of the remote.
1 Press ?/1 while pressing RM
SET UP.
The AMP and ZONE buttons flash.
2 Press ZONE.
The AMP button goes off, the ZONE
button keeps flashing and the SHIFT
button lights up.
3 Press SHIFT, then press the
numeric button 2 for the zone 2,
or 3 for the zone 3 while the
ZONE button is flashing.
The ZONE button lights up.
4 Press ENTER.
The ZONE button flashes twice and the
remote switches to zone 2 or zone 3
mode.
Operating the receiver
from another zone
(ZONE 2/ZONE 3 operations)
The following operations are described for
connecting an IR repeater and operating the
receiver in zone 2 or zone 3. When an IR
repeater is not connected, use this receiver in
the main zone.
1 Turn on the main receiver (this
receiver) and the amplifier in
zone 2 or zone 3.
ZONE
AMP
2, 3
ENTER
SHIFT
RM SET
UP
?/1
ZONE
?/1
MASTER
VOL
Input
buttons
SOURCE
SHIFT
continued
To Next Page
Loading...
Need help?
General