115
GB
Adjusting Settings
1 Select the zone for which you want to
adjust the volume, then press .
2 Select “Volume,” then press .
3 Adjust the volume, then press .
To preset the volume for main
zone/zone 2
You can preset the volume of turning the
power on for each zone.
1 Select the zone for which you want to
preset the volume, then press .
2 Select “Preset Volume,” then press .
3 Adjust the volume, then press .
During the adjustment, the sound is output
at the volume level to which you have
adjusted it, regardless of the value of
MASTER VOLUME control.
If you select “OFF,” each zone is activated
at the same volume as that in effect when
you turned the power off last time.
Note
• You cannot preset the volume for zone 2 in the
following cases.
– “Sur Back Assign” is set to “OFF” or “BI-
AMP.”
– “Zone2 Line Out Level” is set to “FIXED.”
Lets you set the volume control for the ZONE
2 AUDIO OUT jacks to “VARIABLE” or
“FIXED.” For details, see “Set the volume
control for zone 2” (page 92)
x VARIABLE
x FIXED
You can turn the receiver on or off in another
zone, or select various options for use of the
12V Trigger function.
x OFF
Lets you turn off output of 12V triggers even
when the main receiver is turned on.
x Ctrl
Lets you turn the output of 12V triggers on or
off manually using the control command of an
external control device.
x Zone
Lets you turn the output of 12V triggers on or
off based on whether the selected zone is
turned on or off.
x Input
Lets you turn on the output of 12V triggers
when the preset input is selected.
When you select “Input,” the setting display
which sets each input trigger to on/off appears.
Press V/v to select the input, then press to
check the box.
Tip
Even when this receiver is standby mode (press ?/1
on the remote to turned off this receiver), the
receiver in zone 2 or zone 3 remains turned on. To
turn off all receivers, press ?/1 and AV ?/1 on the
multifunction remote at the same time (SYSTEM
STANDBY).
Zone2 Line Out Level
12V Trigger
To Next Page
Loading...
Need help?
General