43
GB
Getting Started
2 Hold down ?/1 for 10 seconds.
The receiver will be rebooted. When the
lamp above ?/1 flashes in green, the reboot
is complete.
Insert two R6 (size-AA) batteries in the RM-
AAL035 or RM-AAL036 remote commander,
and the RM-AAU039 remote commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 139).
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
9: Setting the speakers
Set the appropriate speaker impedance for the
speakers you are using.
1 Press MENU.
The menu is displayed on the TV screen.
2 Press V/v repeatedly to select
“ Settings,” then press or
b.
The Settings menu list appears on the TV
screen.
3 Press V/v repeatedly to select
“Speaker,” then press .
Inserting batteries into the
remote
RM-AAL035
RM-AAL036
RM-AAU039
Setting the speaker impedances
V/v/b,
MENU
RETURN/
EXIT O
continued
To Next Page
Loading...
Need help?
General