127
US
Additional Information
USB FAIL
An over current from the (USB) port
was detected. The receiver will
automatically turn off after a few
seconds. Check the iPod/iPhone or USB
device, then unplug it and turn on the
power again.
For other messages, see “Message list after
Auto Calibration measurement” (page 94),
“iPod/iPhone message list” (page 49),
“USB message list” (page 51) and
“Network features message list” (page 76).
Reference sections
Refer to the following web site for details
of the latest information on the receiver.
For customers in the USA:
http://www.esupport.sony.com/
For customers in Canada:
[English]
http://www.sony.ca/ElectronicsSupport/
[French]
http://fr.sony.ca/ElectronicsSupport/
For customers in Latin America:
http://esupport.sony.com/LA
For customers in Brazil:
http://esupport.sony.com/BR
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA model only)
With 6 ohm loads, both channels driven,
from 20 – 20,000 Hz; rated 100 watts per
channel minimum RMS power, with no
more than 0.09% total harmonic distortion
from 250 milliwatts to rated output.
Amplifier section
USA and Canada models
1)
Minimum RMS Output Power
(6 ohms, 20 Hz – 20 kHz, THD 0.09%)
100 W + 100 W
Stereo Mode Output Power
(6 ohms, 1 kHz, THD 1%)
120 W + 120 W
Surround Mode Output Power
2)
(6 ohms, 1 kHz, THD 0.9%)
165 W per channel
Mexico model
1)
Minimum RMS Output Power
(6 ohms, 20 Hz – 20 kHz, THD 0.09%)
95 W + 95 W
Stereo Mode Output Power
(6 ohms, 1 kHz, THD 1%)
110 W + 110 W
Surround Mode Output Power
2)
(6 ohms, 1 kHz, THD 0.9%)
145 W per channel
Brazil model
1)
Surround Mode Output Power
2)
(6 ohms, 1 kHz, THD 10%)
165 W per channel
Clearing the memory
To clear See
All memorized settings page 90
Customized sound fields page 60
About support
information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
