Sony STR-DN1040 User Manual

39
US
Preparing the Receiver
Depending on the characteristics of the
subwoofer you are using, the setup distance value
may be different from the actual position.
To select the front speakers
You can select the front speakers you want
to drive.
Be sure to use the buttons on the receiver to
perform this operation.
Press SPEAKERS repeatedly to select
the front speaker system you want to
drive.
You can confirm the selected speakers
terminals by checking the indicators on the
display panel.
* To select “SP B” or “SP A+B”, set the
assignment for the SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B
terminals to “Front B Speakers” by using the
“Speaker Connection” in the Speaker Settings
menu (page 95).
This setting is not available when headphones are
connected.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you perform the following
during the measurement process:
– Press ?/1.
– Press the input buttons on the remote
control or turn the INPUT SELECTOR
on the receiver.
– Press .
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
To set up the receiver
manually
See “Adjusting Settings” (page 90).
Configuring the network
settings of the receiver
The network settings for the receiver must
be set correctly to use the Home Network,
SEN, AirPlay, and PARTY STREAMING
functions.
There are several connecting methods you
can use to set up a wireless network:
searching for an access point, using a WPS
connecting method (either the push-button
method or the PIN code method), or
manual setting.
Note
Indicators Selected speakers
SP A The speakers connected to the
SPEAKERS FRONT A
terminals.
SP B* The speakers connected to the
SPEAKERS SURROUND
BACK/BI-AMP/FRONT
HIGH/ FRONT B terminals.
SP A+B* The speakers connected to
both the SPEAKERS FRONT
A and SPEAKERS
SURROUND BACK/
BI-AMP/FRONT HIGH/
FRONT B terminals (parallel
connection).
“SPK OFF” appears on the
display panel. No audio
signals are output from any
speaker terminals.
SPEAKERS
Note
Using a wireless LAN
connection

Sony STR-DN1040 Specifications

General

Receiver type	-
Audio output channels	7.2 channels
Power output per channel (1KHz@8 Ohm)	165 W
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	4
Digital audio optical in	1
Connectivity technology	Wired & Wireless
Wi-Fi	Yes
Ethernet LAN	No
Product color	Black
Audio decoders	Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, DTS, DTS 96/24, DTS-HD
Apple docking compatibility	Not supported
Audio formats supported	AAC, FLAC, MP3, WAV, WMA

Weight and Dimensions

Depth	329.4 mm
Width	430 mm
Height	172 mm