Sony TRINITRON BVM-8045QD User Manual

3-1
S MIC Chassis
SECTION 3
SET-UP ADJUSTMENTS
3-2. PREPARATIONS
The following adjustments should be made when a
complete realignment is required or a new picture tube is
installed. These adjustments should be performed with
rated power supply voltage unless otherwise noted.
The controls and selectors below should be set as follows
unless otherwise noted.
Front Panel Controls
VOLUME control.......................... 50 %
CONTR control ............................. 80 %
PHASE control .............................. 50 % (center click)
CHROMA control ......................... 50 % (center click)
BRIGHT control ............................ 50 % (center click)
APER control................................. 50 % (center click)
Front Panel Selectors
SYNC INT/EXT selector .............. Pull (INT)
LINE/RGB selector ....................... Pull (LINE)
A/B, RGB/Y R-Y B-Y selector ..... Pull (RGB)
BLUE ONLY selector ................... Pull (OFF)
UNDER SCAN selector ................ Pull (OFF)
H/V DELAY selector .................... Pull (OFF)
16 : 9 selector................................. Pull (4 : 3)
Rear Panel Control
V HOLD control ............................ Stable position
Perform the adjustment in order as follows:
3-3. Landing Adjustment
3-4. Convergence Adjustment
3-5. Focus Adjustment
3-6. White Balance Adjustment
3-1. EQUIPMENT REQUIRED
. Oscilloscope Tektronix 2465 or equivalent (band width: 350 MHz or more)
. NTSC, PAL, SECAM component signal generator
Tektronix TG2000 + AVG1 (optional module) + AWVG1 (optional module) or equivalent
. Monoscope signal generator Shibasoku TP22AX or equivalent
. Frequency counter Advantest TR5821AK or equivalent
. Digital voltmeter Advantest TR6845 or equivalent
. Variable step-up transformer
(or NF power supply)
. High-tension meter
. Regulated DC power supply
. Ammeter
. Luminance meter

Sony TRINITRON BVM-8045QD Specifications

General

Brand	Sony
Model	TRINITRON BVM-8045QD
Category	Monitor
Language	English