389
The NFS server address is displayed in the “NFS
Server Address” field.
3
To register the setting as a power-on default, press
[Define].
4
Check the message, then press [Yes].
Mounting the NFS server
In the Engineering Setup >System >Network Config menu
(7311), press [NFS Mount], turning it on.
The configured NFS server is mounted, ready for use.
Resetting the menu panel will unmount the NFS server.
To use an NFS server after resetting the menu panel,
mount the server again.
Initializing Network Interface
Settings
You can initialize the network interface settings for a
network connector board.
For details about network interface settings, see
“Configuring a Network Interface” (page 389).
1
In the Engineering Setup >System >Network Config
menu (7311), press [Net I/F Initialize].
The Net I/F Initialize menu (7311.1) appears.
2
In the <Device> group, select the target switcher to set.
3
In the status area, select the target slot to set.
To select all slots, press [ALL].
4
Press [Factory Reset].
To reset a connector board only
Press [Reset].
5
Press [Execute].
6
Check the message, then press [Yes].
Setting the Network Connector
Board Service Port
The service port can be enabled/disabled when an
XKS-C8111/XKS-C9111/XKS-C9111N/XKS-C9121/
XKS-C9121N/XKS-C8166 is installed.
The service port is used for board maintenance.
The unit is equipped with a function to perform board
maintenance via a network. If maintenance is required, this
function is used with the consent of the customer. For
details, consult your Sony service or sales representative.
1
In the Engineering Setup >System >Network Config
menu (7311), press [Net I/F Initialize].
The Net I/F Initialize menu (7311.1) appears.
2
In the <Device> group, select the target switcher to set.
3
In the status area, select the target slot to set.
To select all slots, press [ALL].
4
Enable or disable the service port.
To enable, press [Service Port], turning it on.
To disable, press [Service Port], turning it off.
5
Press [Execute].
6
Check the message, then press [Yes].
The connector board in the selected slot is reset, and
the service port setting is applied.
If the network interface is initialized (see page 389)
and the service port setting is applied simultaneously
to the same slot, the initialization operation takes
precedence, and the service port setting is not changed.
Configuring a Network Interface
You can configure the interface for a network connector
board.
The network interface settings are for the slots in which the
following network connector boards are installed.
XVS-9000:
• XKS-C9111
• XKS-C9111N
• XKS-C9121
• XKS-C9121N
XVS-8000/7000/6000:
• XKS-T8110
• XKS-Q8111
• XKS-C8111
• XKS-T8165
• XKS-Q8166
• XKS-C8166
Note
Note
Note
To Next Page
Loading...
Need help?
General
