March 2016 DocID027916 Rev 2 1/79
1
UM1902
User manual
Evaluation board with STM32F746NG MCU
Introduction
The STM32746G-EVAL evaluation board is a complete demonstration and development
platform for STMicroelectronics ARM
®
Cortex
®
-M7 core-based STM32F746NGH6
microcontroller. It features four I
2
C interfaces, six SPIs with three multiplexed simplex I
2
S
interfaces, SDMMC, four USARTs, four UARTs, two CANs, three 12-bit ADCs, two 12-bit
DACs, two SAIs, 8 to 14-bit digital camera module interface, internal 320+4-Kbyte SRAM
and 1-Mbyte Flash memory, USB HS OTG and USB FS OTG, Ethernet MAC, FMC
interface, Quad-SPI interface, JTAG debugging support. This evaluation board can be used
as a reference design for user application development but it is not considered as a final
application.
The full range of hardware features on the board helps the user to evaluate all peripherals
(USB OTG HS, USB OTG FS, Ethernet, Motor control, CAN, microSD card, USART, Audio
DAC and ADC, digital microphone, IrDA, RF-EEPROM, SRAM, Nor Flash memory,
SDRAM, Quad-SPI Flash memory, 5.7" TFT LCD with a capacitive touch panel and others)
and to develop his applications. Extension headers make it possible to easily connect a
daughterboard for a specific application.
The integrated ST-LINK/V2-1 provides an embedded in-circuit debugger and programmer
for the STM32.
Figure 1. STM32746G-EVAL evaluation board
1. Picture not contractual.
www.st.com
To Next Page
Need help?
General
