Legacy U.S.A. (E)
3
Instruments and controls
3-19
– CONTINUED –
the wiper operation is jerky, clean the outer surface of the windshield (or
rear window) and the wiper blades using a sponge or soft cloth with a
neutral detergent or mild-abrasive cleaner. After cleaning, rinse the wind-
shield and wiper blades with clean water. The windshield is clean if
beads do not form when you rinse the windshield with water.
D If you cannot eliminate the streaking even after following this method,
replace the wiper blades with new ones. Refer to the Wiper Blade
Replacement section (chapter 10) for replacement instructions.
J Windshield wipers and washer switch
B Windshield wipers
OM-H0363
To turn the wipers on, push the wiper control lever down.
INT: Intermittent
LO : Low speed
HI : High speed
To turn the wipers off, return the lever to the “OFF” position.
To Next Page
Loading...
Need help?
General
