Legacy U.S.A. (E)
1-20
To unlock all doors (and the rear gate on the wagon), briefly press the
“UNLOCK/DISARM” button a second time.
B Emergency disarming
If you cannot disarm the system using the transmitter (i.e. the trans-
mitter is lost, broken or the transmitter battery is too weak), you can
disarm the system without using the transmitter.
To disarm the system:
1. Unlock the door with the key and then open the door.
2. The alarm will sound.
3. Insert the key into the ignition switch and cycle it from the “LOCK”
to the “ON” position three (3) times within 5 seconds.
J Sounding a panic alarm
To activate the alarm, keep the “LOCK/ARM” button pressed for more
than two seconds.
To deactivate it, press the “LOCK/ARM” button or “UNLOCK/DISARM”
button.
The parking lights will also flash when the alarm is activated.
Unless a button on the remote is pressed, the alarm will be deactivated
after approximately 30 seconds.
J Valet mode
When you choose the valet mode, the security system does not operate.
In valet mode, the remote transmitter is used only for locking and unlock-
ing the doors (and rear gate on the wagon) and panic activation.
To enter the valet mode, open the driver’s door and keep the “UNLOCK/
DISARM” button depressed for more than two seconds. The indicator
light on the instrument panel repeatedly flashes two times while the sys-
tem is in valet mode.
To exit valet mode, open the driver’s door and keep the “UNLOCK/DIS-
ARM” button pressed for more than two seconds. The indicator will
stop flashing.
To Next Page
Loading...
Need help?
General
