Legacy U.S.A. (E)
1
Doors and locks
1-19
– CONTINUED –
B To arm the system using power door locking switches
HB1009BB
7
6
1. Close all windows and sunroofs (if so equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood and the trunk lid are locked.
5. Close the doors (and the rear gate on the wagon) but leave only
the driver’s door or the front passenger’s door open.
6. Press the upper part of the power door locking switch (“LOCK”
side) at the door to set the door locks.
7. Close the door. The horn will sound one time, the parking lights will
flash one time and the indicator light on the dashboard will start flash-
ing slowly (approximately once every two seconds) to inform you that
the system has armed.
NOTE
The system can be armed even if the engine hood, the trunk lid, the win-
dows and/or sunroofs are opened. Always make sure that they are fully
closed before arming the system.
J Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less than two seconds)
on the remote transmitter. The driver’s door will unlock, the horn will
sound two times, the parking lights will flash two times and the indicator
light will go off.
To Next Page
Loading...
Need help?
General
