10 Operation of LCD Display Panel User Manual
70
On the “Energy-adj” screen, Press h to move cursor right
and Press j to set the correct offset value.
Confirm settings by pressing ENTER.
The positive symbol “+” can be changed to the negative
symbol “-”.
The adjustment range is from -9999 to +9999 kWh.
(Energy-adj value)= (Real measured value)-(E-tot reading
value).
10.9.4 Load Default
All history accumulated information will be unrecoverable cleared and all
parameters will return to the default value except the protective
parameters and time, once the “load default” operation is performed.
Main Screen(Press ENTER ) →Menu screen(Press j ×3) → Set-param
(Press ENTER) →Enter password(Press ENTER ) →Sys-param (Press ENTER,
Press j×3 ) → Load default (Press ENTER)
A password confirmation screen will occur. Press h to
move cursor right and Press j to input the password
111111.
Press ENTER to confirm “load default”.
10.9.5 Firmware Version
Main Screen(Press ENTER ) →Menu screen(Press j ×3) → Set-param
(Press ENTER) →Enter password(Press ENTER) →Sys-param (Press ENTER,
Press j×4) → Firmware version (Press ENTER)
Inverter shows detailed firmware information, including
LCD version and DSP version.
The firmware version information is read only.
To Next Page
Loading...
Need help?
General