64
If there is a fault, the “Work State” will show
“Fault”. Tap the “Fault” cell.
The state column of the module unit that has fault
will display “Fault". As shown in the left figure, a
fault occurs to inverter unit 1. Tap the fault cell of
inverter unit 1 to check the present fault.
The fault interface of inverter unit 1 will appear with
the fault item in red.
9.10 Starting/Stopping
Usually, the inverter will start automatically when the grid-connected
requirements are met.
Start/stop the inverter through the LCD screen in either of the following manners:
• Tap “Start/Stop” on the default menu.
• Tap “Start/Stop” from the Function menu.
Start or stop the inverter by tapping the start/stop button on the screen.
A confirm operation interface will appear after tapping the corresponding buttons. The
instruction takes effect after confirmation; or the user can cancel the operation by
tapping “Cancel”.
9.11 Loading Default
Proceed as follows to restore factory defaults:
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Sys-parameter” after entering the correct password.
step 4 Tap “Load default” and the password inputting window appears.
9 LCD Menu Operation System Manual
To Next Page
Loading...
Need help?
General
