POWER TRIM AND TILT 8-10
PTT MOTOR
Removal
Remove the four (4) screws securing the PTT motor to the pump
& reservoir.
Detach the PTT motor from pump & reservoir.
Note the position of drive joint 1 and O-ring 2 and remove
them.
PTT motor Disassembly
For correct assembly, scribe an alignment mark on the field case
and brush holder.
Remove the three (3) screws securing the field case to the brush
holder.
Using a soft face hammer, gently tap the field case from side to
side to unseat it from the brush holder.
Slide the field case upward and away from the brush holder.
Note the position of the O-ring encircling the brush holder.
Slide the armature free of the brushes.
1. Screw
2. Field case
3. Armature
4. O-ring
5. Brush holder
1
2
3
4
5
To Next Page
Loading...
Need help?
General
