Tascam Sonicview 16 User Manual

6 – Modules
FX RTN 1–4 module
MIX 1–22 modules
MIX 1–22 modules with Stereo Link on
MAIN L/R Master module
1 SEND levels, SEND PAN and ON/OFF buttons for
MIX 1–22 buses
This shows the SEND settings for MIX 1–22 buses.
a This shows the user module names for the MIX 1–22
modules. If the name has not been defined, the MIX
module number, for example “1”, will be shown.
b This shows the send position settings for the MIX 1–22
buses.
No indicator Set to POST FADER
PRE Set to PRE FADER
c Use this to adjust the send levels to the MIX 1–22
buses. When a selection frame is shown, use
corresponding LCD knobs (lit orange) to adjust values.
Assignment on Shown in orange
Assignment off Shown in gray
Range: -∞ dB – +10 dB (default: -∞ dB)
d Tap this button to turn on/off signals sent to the MIX
1–22 buses.
Module default
CH 1–40/ST IN 1–2/FX RTN 1–4 ON
MIX 1–22/MAIN L/R Master OFF
e This adjusts the SEND PAN of the signal sent to the
MIX 1–22 buses. When a selection frame is shown, use
corresponding LCD knobs (lit yellow) to adjust values.
Range: L100 – C – R100 (default: C)
f Rounded buttons are shown for MIX 1–22 modules set
to GROUP buses. Tap this button to turn it on and off.
NOTE
i A list of SEND settings for each bus can be viewed and
operated (“MIX 1–22 bus SEND OVERVIEW Screen” on page
149).
i Tap the SEND level area while pressing the HOME key on the
top panel to set the SEND level for that bus to 0 dB.
i Tap the SEND PAN area while pressing the HOME key on the
top panel to set the SEND PAN for the tapped bus to center
(C).
TASCAM Sonicview 16/Sonicview 24 V1.1.0 141

Tascam Sonicview 16 Specifications

General

Brand	Tascam
Model	Sonicview 16
Category	Music Mixer
Language	English