107
10 INTERNET SECURITY
DMS-CTC-20110713-0016 v2.0
10.4 Wireless Time Control
Introduction
Wireless Time Control allows you to restrict wireless access to one or two sessions. This means that your wireless devices will
not be able to connect to the Internet (or your local network) outside these time frames.
Warning
Make sure that the persons that use a wireless connection are aware of these time frames. This to avoid the loss of data or
unexpected service interruption.
Requirements
Before you can start:
Your MediaAccess Gateway must be connected to the Internet.
Your MediaAccess Gateway must use a time server for its time configuration.
For more information, see “9.4 Network Time Server” on page 94.
Procedure
1 Browse to the MediaAccess Gateway GUI.
For more information, see “4.1 MediaAccess Gateway GUI” on page 36.
2 On the Home Network, click Access Control.
3 The Access Control page appears. In the Pick a task list, click Wireless Time Control.
4 The Wireless Network Time Control page appears.
5 Select the Enable Schedule box.
6 Select a start time and end time for the first session.
7 Select a start time and end time for the second session.
8 Click Apply.
Depending on the software version used by your service provider, this feature may not yet be available on your
MediaAccess Gateway.
To Next Page
Loading...
Need help?
General
