87
(Continued)
To restore all the settings to the
factory defaults
When the following situations occur, reset the
memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 Press [SETUP].
2 Press [
], [ ] repeatedly to select
“Initialization” and then press [OK].
3 Press [
], [ ] to select “Yes” and then
press [OK].
• A confirmation screen appears. Select “Yes” in
the following steps to restore all the settings to
defaults.
4 Press [ ], [ ] to select “Yes” and then
press [OK] again.
Note
• If the setup menu cannot be entered, disconnect
the AC mains lead and reconnect while pressing
and holding [ ] after approx. 3 minutes or
later for restoring all the settings to the factory
defaults. (“Initialized” is displayed.)
General
The unit does not work.
Operations are not done properly.
• One of the unit’s safety devices, etc. may have
been activated.
Press [ ] on the unit to switch the unit to
standby.
• If the unit does not switch to standby, press
[
] on the unit for at least 5 seconds. The
unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead,
wait for at least 3 minutes, then reconnect it.
Press [ ] on the unit to switch on. (It may take
some time for this unit to be turned on.)
• If the unit still cannot be operated, consult the
dealer.
• The remote control may not work properly. (⇒ 93)
• The touch switch operation may be disabled.
Check the setting. (⇒ 82)
To Next Page
Loading...
Need help?
General
