Tektronix 2215A Operator's Instruction Manual

General lnformation-2215A Operators
Table 1-1 (cont)
Characteristics
Performance Requirements
Supplemental Information
HORIZONTAL DEFLECTION SYSTEM
Sweep Rate
Calibrated Range
A Sweep
0.5 s per division
to 0.05 µs per
division in a 1-2-5 sequence. X10
magnifier extends maximum sweep
speed
to 5 ns per division.
B Sweep
50
ms per division to 0.05 µs per
division
in a 1-2-5 sequence. X10
magnifier extends maximum sweep
speed
to 5 ns per division.
Accuracy
Unmagnified
Magnified
Sweep accuracy applies over the
•
center 8 divisions. Exclude the first
+ 15°C
to + 35°C
± 3%
± 4%
25
ns of the sweep for magnified
sweep speeds and anything beyond
0°c
to + 50°c
± 4%
± 5%
the 100th magnified division.
POSITION Control Range
Start
of sweep to 10th division in X 1 or
100th divisions in X10 will position past
the center vertical graticule line.
Sweep Linearity
± 7%.
Linearity measured over any 2
of the
center 8 divisions. With magnifier in X10,
exclude the first 25
ns and anything past
the 100th division.
Variable Control Range
Continuously variable between
calibrated settings. Extends the A and
B sweep speeds by
at least a factor of
2.5.
Delay Time
Applies to 0.5
þÿ¼s per division
Delay time
is functional but not
and slower.
calibrated
at sweep settings above 0.5 þÿ¼s
per division.
Dial Control Range
< 0.5 + 300 ns
to > 10 divisions.
Jitter
One part
or less in 20,000 (0.005%) of
the maximum available delay time.
Differential Time Measurement
Exclude delayed operation when A and B
Accuracy
SEC/DIV knobs are locked together
at
+ 15°C to + 35°c
± 1 %
+0.015 major dial division
any sweep speed
or when A SEC/DIV
switch is
at 0.5 þÿ¼s per division or faster.
o· c
to + 50°c
±
2% +0.015 major dial division.
Acc
ur acy applies over the B DELAY TIME
POSITION control range.
1-4

Tektronix 2215A Specifications

General

Brand	Tektronix
Model	2215A
Category	Test Equipment
Language	English