Tektronix 475 Technical Manual

TM 11-6625-2735-14-1
TABLE 5-1
Test Equipment Required For Performance Check
Description
1. Amplitude Calibrator
2. Sine-Wave Generator
3. Time-Mark Generator
4. Low-Frequency
Generator
5. Cable (2 required)
6 Cable (2 required)
7 50-Ohm Signal
Pickoff
8 Adapter
Minimum
Specifications
Amplitude accuracy, within
0.25%; signal amplitude, 2
millivolts to 20 volts; output
signal, 1 kilohertz square
wave.
Frequency, 350 kilohertz to
above 200 megahertz; output
amplitude, variable from 15
millivolts to 4 volts peak-to-
peak; output impedance, 50
ohms; reference frequency,
50 to 350 kilohertz; ampli-
tude accuracy, constant with
in 3% of reference frequency
as output frequency changes.
Marker outputs, 2 nano-
seconds to 0.5 second;
marker accuracy, within
0.1%; trigger output, 1 milli-
second to 0.1 microsecond,
lime coincident with markers.
Frequency, 10 Hertz to 50
kilohertz; output amplitude,
variable from 10 millivolts to
4 volts peak-to-peak.
Impedance, 50 ohms: length,
42 inches; connectors, BNC.
Impedance, 50 ohms, length
18 inches, connectors. BNC.
Frequency response, 50 kilo-
hertz to 875 megahertz: im-
pedance, 50 ohms for signal
input, signal output and trig-
ger output.
Connectors, BNC Female to
BNC Female.
Usage
Vertical checks. Trigger view
gain check; External Z-Axis
check.
Vertical centering, bandwidth
and isolation checks; Trigger
checks: X bandwidth check.
Horizontal timing checks.
Low-frequency trigger checks.
Used throughout procedure
for signal interconnection.
Used throughout procedure
for signal interconnection.
Trigger checks.
Used throughout procedure
for signal interconnection.
Examples
a. Tektronix PG 506 Cali-
bration Generator.
1
b. Tektronix 067-0502-01
calibration fixture.
a. Tektronix SG 503 Leveled
Sine-Wave Generator.
1
(Use
for all frequencies.)
b. Tektronix Type 191
Constant-Amplitude
Signal
Generator. (Use at fre-
quencies of
100 megahertz
and below).
AND
Wavetek Model 1001A (use
only for checking 200 mega-
hertz bandwidth and trig-
gering.)
a. Tektronix TG 501 Time-
Mark Generator.
1
b. Tektronix 2901 Time-
Mark Generator.
a. Tektronix SG 502 Oscil-
lator.
1
b General Radio 1310 B Os-
cillator with a binding post to
BNC adapter.
a Tektronix Part Number
012-0057-01.
a Tektronix Part Number
012-0076-00.
a Tektronix CT-3 Signal
Plckoff. Part Number
017-0061-00.
a. Tektronix Part Number
103-0028-00.
1
Requires a TM 500-Series Power Module.
5-2

Tektronix 475 Specifications

General

Brand	Tektronix
Model	475
Category	Test Equipment
Language	English