To Next Page

To Previous Page

3. Record the reference level:

■

Disconnect the sine wave generator from the instrument.

■

Connect the sine wave generator to the power sensor.

■

Note the level meter reading.

4. Set the generator to the new frequency and reference level:

■

Change the sine wave generator to the desired new frequency.

■

Input the correction factor and/or the new frequency into the level meter.

■

Adjust the sine wave generator amplitude until the level meter again

reads the value noted in step 3. The signal amplitude is now correctly set

for the new frequency.

■

Disconnect the sine wave generator from the power sensor.

■

Connect the sine wave generator to the instrument.

Performance verification (MSO/DPO70000C, MSO/DPO70000DX, and DPO7000C series)

284 MSO70000C/DX, DPO70000C/DX, DPO7000C, MSO5000/B, DPO5000/B Series

Tektronix DPO5000 Series Technical Reference

Other manuals for Tektronix DPO5000 Series