Tektronix DPO70000C/DX Series User Manual

Analyzing wavef
orms
4. To take measure
ments between two
waveforms, s e lect Waveform, and then
select the waveform source for each
cursor.
5. Select Cursors > Cursor Position...,
and then us
e the multipurpose knobs to
adjust the cursor position.
6. Read cursor measurement results in the
display.
Quick tips
Use th
e Cursor Track Mode to set the cursors to move in tandem. Use the Cursor Independent mode to move the
cursors separately.
If you use the zoom graticule, you c an place a cursor directly on a specific w aveform point to take precision
measurements.
You can also move cursors by clicking and dragging them to a new position.
You can also move cursors to the center of the display by pressing Move Cursors to Center.
You can select solid or dashed cursors.
Vertical cursors measure the time from the trigger point to the vertical cursor.
MSO/DPO70000DX, MSO/DPO70000C, DP O7000C, and MS O/DPO5000 Series U ser M anual 123

Tektronix DPO70000C/DX Series Specifications

General

Brand	Tektronix
Model	DPO70000C/DX Series
Category	Test Equipment
Language	English