Appendix D: Rackmounting the Instrument (SPG600 Option 1R Only)
SPG600 & SPG300 Sync Pulse Generators User Manual D-5
Installing the Instrument
1. Working from the front of the rack, pull the inner track of each slide-out track
assembly until it extends out the front of the rack. Continue to pull them out
until they lock.
2. Insert the instrument left and right tracks into the ends of the rack tracks just
extended. Make sure to insert the instrument tracks inside of the inner rack
tracks extended in step 1.
3. Push the instrument into the rack until it stops.
4. Push both stop latches, located on the outside of each track, and continue to
slide the instrument all the way into the rack.
5. Tighten the two screws that were left loose at the rear of the rack when you did
step 3 in Mounting the Slide-Out Tracks on page D-4, and then pull the
instrument part way out of the rack.
6. Be sure the two screws that were left loose at the front of the rack are loose
enough to allow the slide-out track assemblies to seek the appropriate
positions.
7. Retighten the two screws and push the instrument all the way into the rack. If
the tracks do not slide smoothly, readjust the rail assemblies using the method
just detailed.
8. When adjusting is completed, tighten all rail assembly 10-32 screws using
28 inch-lbs of torque.
9. Using a number two phillips screwdriver, install the 10-32 screw attached to
your rack in one of the two mounting holes at the right side of the front panel.
Repeat for the second mounting hole. Tighten both screws using 25 inch-lbs of
torque.
10. Repeat step 9 to install the two screws in the left side of the front.
To Next Page
Loading...
Need help?
General
