Getting Started
1-4 SPG600 & SPG300 Sync Pulse Generators User Manual
Connecting the Power Cable. Connect the power cable to the instrument first, and
then connect it to the AC power source. Note that connecting the power cable
causes the instrument to power on.
After connecting the power, make sure that the fan inside the instrument is
working. If the fan is not working, turn off the power by disconnecting the power
cable from the AC power source and contact your local Tektronix Field Office or
representative.
Repackaging for Shipment
When you ship this instrument, use the original packaging material if possible. If
the original packaging is unfit for use or is not available, repackage the instrument
using the following procedure:
1. Obtain a corrugated cardboard shipping carton having inside dimensions at
least six inches greater than the instrument dimensions and having a carton test
strength of at least 125 kg (275 pounds).
2. If the instrument is being shipped to a Tektronix Service Center for repair or
calibration, attach a tag to the instrument showing the following information:
The owner of the instrument (with address).
The name of a person at your company who may be contacted if additional
information is needed.
The complete instrument type and serial number.
A description of the service required.
3. Wrap the instrument with polyethylene sheeting or equivalent to protect the
outside finish and prevent entry of packing materials into the instrument.
4. Cushion the instrument on all sides by tightly packing dunnage or urethane
foam between the carton and the instrument, allowing for three inches
(7.62 cm) of padding on each side (including top and bottom).
5. Seal the carton with shipping tape or with an industrial stapler.
6. Mark the carton with the address of the Tektronix Service Center and your
return address in one or more prominent locations.
To Next Page
Loading...
Need help?
General
