Tektronix TBS1000C Series User Manual

Selecting which device is attached to the USB Device port
Use this procedure to select which device is connected to the USB Device port.
A supported device does not need to be connected to the USB Device port to
select that item.
NOTE. The current software release only supports a PC connection.
1. Push Utility front-panel button.
2. Push the Config side-menu button. The USB menu item (at top of the Config
side menu) shows the USB Device port connection status.
3. Use the Multipurpose knob to select and click USB. The USB Device Port
menu lists available devices to which you can connect. A grayed out menu
item cannot be selected.
4. If the USB Device port is Disabled (off Bus), select and click the device to
which you want to connect.
Setting or viewing USB Device port parameters
148 TBS1000C Series Oscilloscopes User Manual

Tektronix TBS1000C Series Specifications

General

Brand	Tektronix
Model	TBS1000C Series
Category	Test Equipment
Language	English