Tektronix TBS2000 Series User Manual

Syntax
ERRLOG:NEXT?
Returns
Refer to the service manual for your instrument for information about error log
message format.
*ESE
Sets and queries the bits in the Event Status Enable Register (ESER). The ESER
prevents events from being reported to the Status Byte Register (STB). For a
detailed discussion on how to use registers, see Registers. Command only, no
query form.
Group
Status and Error
Syntax
*ESE <NR1>
*ESE?
Related Commands
*CLS on page 75, DESE on page 96, *ESR? on page 107, EVENT? on page 115,
EVMsg? on page 116, *SRE on page 219, *STB? on page 220
Arguments
<NR1> is a value in the range from 0 through 255. The binary bits of the ESER
are set according to this value.
The power-on default for ESER is 0 if *PSC is 1. If *PSC is 0, the ESER
maintains its value through a power cycle.
NOTE. Setting the DESER and the ESER to the same value allows only those
codes to be entered into the Event Queue and summarized on the ESB bit (bit 5)
of the Status Byte Register. Use the DESE command to set the DESER. SeeEvent
Handling Sequence on page 280.
E commands
106 TBS2000 Series Programmer

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English