Execution Warning
The following table lists warning messages that do not interrupt the flow of
command execution. They also notify you of a possible unexpected results.
Table 36: Execution warning messages (EXE bit 4)
Code Message
528 Parameter out of range
532 Curve data too long, Curve truncated
533 Curve error, Preamble values are inconsistent
540 Measurement warning, Uncertain edge
541 Measurement warning, Low signal amplitude
542 Measurement warning, Unstable histogram
543 Measurement warning, Low resolution
544 Measurement warning, Uncertain edge
545 Measurement warning, Invalid in minmax
546 Measurement warning, Need 3 edges
547 Measurement warning, Clipping positive/
negative
548 Measurement warning, Clipping positive
549 Measurement warning, Clipping negative
Table 37: Execution warning messages (EXE bit 4)
Code Message
540 Measurement warning
541 Measurement warning, Low signal amplitude
542 Measurement warning, Unstable histogram
543 Measurement warning, Low resolution
544 Measurement warning, Uncertain edge
545 Measurement warning, Invalid min max
546 Measurement warning, Need 3 edges
547 Measurement warning, Clipping positive/
negative
548 Measurement warning, Clipping positive
549 Measurement warning, Clipping negative
Internal Warning
The following table shows internal errors that indicate an internal fault in the
instrument.
Table 38: Internal warning messages
Code Message
600 Internal warning
Status and Events
TBS2000 Series Programmer 293
To Next Page
Loading...
Need help?
General
