ThermoSpas Designer Series User Manual

24
Programming Instructions
Programming the Time
When power is rst applied and the Priming Mode has nished, the control panel will display the
time icon (TIME). You will need to program the time of day by following the steps below. If the
time is not programmed the LCD screen will ash the “Time” icon until it is programmed.
1. Press the Time ( ) button.
2. Press the Mode/Prog ( ) button to enter the hour setup.
3. Press the Warm ( ) or Cool ( ) button to adjust the hour.
4. Press the Mode/Prog ( ) button to enter the minutes setup.
5. Press the Warm ( ) or Cool ( ) button to adjust the minutes.
6. Press the Time ( ) button to exit the menu.
Note:
• To view the time press the Time button and the LCD screen will display the current time.
• Any time power is cut to the spa, the time will have to be reprogrammed (except for the
Diamond models).
Standard Mode
Standard Mode constantly maintains the set temperature, assuming too many pumps aren’t
running. Heating will occur until the water reaches the next highest degree about the temperature
set-point. The Standard (STANDARD) icon will be displayed unless the mode is changed. When
in standard mode the heater will turn on as needed. To program the spa to run in standard mode:
1. Press the Mode/Prog ( ) button to enter the mode programming.
2. Press the Cool ( ) button to scroll through the mode settings: STANDARD, ECONOMY
and SLEEP.
3. The current mode will ash on the LCD screen until a selection is conrmed and
programmed.
4. Once the Standard mode is displayed on the LCD screen, press the Mode/Prog ( )
button to conrm and exit the menu.
5. The “STANDARD” icon will be constantly displayed on the LCD screen as an indication of
the mode the spa is currently set to.
Note: In regions where the climate is hot you need to consider heat transfer. As the pumps run
they produce heat that can raise the water temperature. If you experience multiple overheating
problems call the technical service department and lower the temperature to the lowest setting.
Economy Mode
Allows the spa to heat only during the preset heating cycles, page 25. Heating will occur un-
til the water reaches the next highest degree about the temperature set-point. The Economy
(ECONOMY) icon will be displayed unless the mode is changed. When in economy mode the
heater will turn on only when there is a heat call during a programmed heating cycle. To program
the spa to run in economy mode:
1. Press the Mode/Prog ( ) button to enter the mode programming.
2. Press the Cool ( ) button to scroll through the mode settings: STANDARD, ECONOMY
and SLEEP.
3. The current mode will ash on the LCD screen until a selection is conrmed and
programmed.
4. Once the Economy mode is displayed on the LCD screen, press the Mode/Prog ( )
button to conrm and exit the menu.
5. The “ECONOMY” icon will be constantly displayed on the LCD screen as an indication of the
mode the spa is currently set to.
Programming Instructions

ThermoSpas Designer Series Specifications

General

Brand	ThermoSpas
Model	Designer Series
Category	Hot Tub
Language	English