ThyssenKrupp Flow2 Assembly Instruction

2007.03.07Flow2 stairliftTab 04: Install, adjust and release
www.ThyssenKruppAccessibility.nl12
Assembly
3.2 Preparing to drive onto the rail
1. Remove the service cover.
2. Fit the fuse (40 A) in the drive unit, the fuse is located in the handle.
3. Turn on the drive unit by pulling the red main switch, on the rear of the drive unit, up a few
millimeters.
4. Check that the mode knob on the service board is set to mode 3.
Fig. 3-1 Prepare the drive unit
1
1 1
Fig. 3-2 Remove the service
cover
1
Fig. 3-3 Fuse in drive unit
1
Fig. 3-4 Switch on drive unit
1
TIP
When switching on the lift an audio signal will be heard. The three-digit release number
will also be shown in the service unit display.

ThyssenKrupp Flow2 Specifications

General

Brand	ThyssenKrupp
Model	Flow2
Category	Stairlifts
Language	English