TomTom GO 6200 User Manual

9
Installing in your car
Use the supplied mount to install your TomTom GO in your vehicle. Read the instructions about
positioning your device before you install your GO.
To install your GO, do the following:
1. Connect the supplied USB cable to the mount. If the mount is integrated into your GO, connect
the USB cable to the device.
Note: Use ONLY the USB cable supplied with your GO. Other USB cables may not work.
2. Connect the USB cable to the USB car charger and plug this into the power supply on your
dashboard.
3. Choose the best smooth location, on your windscreen or side window, to mount your TomTom
GO.
Tip: If the mount is integrated into your GO, you can easily change the rotation of your device.
Push the button on the back of the device to release the mount, then slide the mount out.
Insert it back into the other side of the device.
4. Make sure that both the suction cup on the mount and your windscreen are clean and dry.
5. Press the suction cup of the mount firmly against your windscreen.
6. Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock.
7. If your mount is not integrated into your GO, place your GO in the mount, making sure that it
clicks into place.
Dashboard adhesive disks are available as part of a range of accessories for your GO. For more
information, go to tomtom.com/accessories.
Positioning the device
Be careful where you install your GO. The GO shouldn't block or interfere with any of the following:
 Your view of the road.
 The controls in your vehicle.
 Your rear-view mirrors.
 The airbags.
You should be able to reach your GO easily without leaning or stretching. In a car, you can attach
your GO to the windscreen or side window or you can use a Dashboard Mount Disk to attach the
mount to your dashboard.
Switching on and off
Switching your device on
Press the On/Off button until your device starts. If the device was off you see the map view. If your
device was sleeping you see the last screen you were looking at.
Sending your device to sleep
To send your navigation device to sleep, press the On/Off button and then release it.
Get going

TomTom GO 6200 Specifications

General

Auto	Yes
Marine (chartplotters, sounders)	No
Languages support	Multi
Traffic Message Channel (TMC)	-
Map coverage	All Europe
Lifetime map updates	Roads change, but with Lifetime Map Updates your map will always be up to date. Start fresh every few months by downloading a new edition of the industry's most accurate map. New editions are issued four times per year.
Pixel density	154 ppi
Display diagonal	6 \
Display resolution	800 x 480 pixels
Storage media type	Flash
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	32 GB
Internal storage capacity	16 GB
Form factor	Fixed
Product color	Black, Grey
Supported radio bands	Not supported
Power source type	Battery, Cigar lighter
Battery life (max)	1 h
Cables included	USB

Weight and Dimensions

Width	- mm
Weight	- g