Toro titan zx Service Manual

CHASSIS
3-8
Toro TITAN 2009-2013 Service Manual
3
4. Install and sufciently tighten the (2) thread forming
bolts that secure the rear guard tube (C) to the seat
support (E). OR Install the bolts / nuts securing the
rear engine guard to the ROPS frame (D).
(Fig. 015)
Fig. 013 PICT-2069
Fig. 015 PICT-2070
5. Install the (2) bolts that secure the hydro expansion
tank (A) to the seat support and torque to
specication – 5 ft-lbs (7 Nm).
6. Properly route cables / wiring and reinstall cable ties
/ loom clams to secure them to the seat support.
7. Install LH pod / fender as outlined in this chapter.
8. Connect the battery cables and lower seat.
9. Verify proper function.
Fuel Tank Installation
1. Position the fuel tank assembly into the unit frame.
2. Install the (2) bolts and nuts that secure the seat
support (E) to the frame brackets and torque to
specication – 17 ft-lbs. (23 Nm).
3. Install the fuel tank retaining rod (B) and torque
retaining bolt to specication – 8 ft-lbs. (11 Nm). Be
sure the front rod end is engaged into the control
box assembly (Fig. 013).
B
D
C
Fig. 014 PICT-2066
B
C
E
A

Toro titan zx Specifications

General

Brand	Toro
Model	titan zx
Category	Lawn Mower
Language	English