MOWER DECK
6-24
Toro TITAN 2009-2013 Service Manual
6
Leveling Mower Deck - 50 Inch Deck
Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed and
replaced. Refer to “Checking for Bent Blades” on page
6-20 before continuing.
The mower deck must be leveled side-to-side rst then
the front to rear slope can be adjusted.
Requirements:
• The machine must be on a level surface.
• All four tire must be properly inated.
Checking Side-to-Side Level
The mower blades must be level from side to side.
Check the side-to-side level any time you install the
mower or when you see an uneven cut on your lawn.
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove the
key, set the parking brake and wait for all moving
parts to stop before leaving the operating position.
3. Carefully rotate the blades side to side.
5. Recheck that blocks t just snugly under the deck
skirt. Make sure all attachment bolts are tight.
6. Verify the deck is level by checking the side-to-side
level and front-to-rear blade slope; repeat deck
leveling procedure if necessary.
To Next Page
Loading...
Need help?
General
