Toro titan zx Service Manual

CHASSIS
3-21
Toro TITAN 2009-2013 Service Manual
3
Parking Brake & Linkage Service
Parking Brake & Linkage Removal
1. Tilt seat forward, disconnect and remove the battery.
2. Remove the LH control cover to access the parking
brake handle area.
3. Remove the parking brake pin and washer (A).
Remove the parking brake link from the handle stud
(Fig. 042).
4. Remove fastener (B) that secures the parking brake
handle to the control box assembly. Remove the
handle from the unit (Fig. 042).
5. Remove the brake return spring (C) and the clip and
washer (D) from the brake rod on the hydro (Fig.
043).
Fig. 042 PICT-2076
Fig. 043 PICT-2046
6. Remove all of the clips and washers (E), then
remove the (3) linkage rods from the chassis.
7. Remove the (2) cotter pins (F), (2) washers and
(2) bushings (G) from the brake bell crank (H) (Fig.
044).
Fig. 044 PICT-2083
8. Slide the brake bell crank (H) to one side and
remove the bell crank from the frame.
9. Inspect all linkage rods, pivot points and bushings
for excessive wear, replace if necessary.
A
B
D
C
F

Toro titan zx Specifications

General

Brand	Toro
Model	titan zx
Category	Lawn Mower
Language	English