Toro titan zx Service Manual

HYDROSTATIC DRIVE SYSTEM
5-6
Toro TITAN 2009-2013 Service Manual
5
2. Hold the pivot bolt in position with a 1/4” hex wrench,
and then slightly loosen the eccentric pivot nut (A)
(Fig. 069).
Fig. 069 PICT-6488
3. Use a 1/4” hex wrench to adjust the eccentric pivot
bolt until the unit tracks straight (Fig. 070).
Fig. 070 PICT-6495
Fig. 068 PICT-2040
Tracking Adjustment
Note: Do not make tracking adjustments on cold
hydrostatic drive systems. Safely warm the
drive system before making adjustments.
- Adjust the eccentric on the LEFT side if the unit
pulls to the RIGHT
- Adjust the eccentric on the RIGHT side in the unit
pulls to the LEFT.
1. Remove the (1) bolt that secures the control panel
cover to access the adjustment eccentric (Fig. 068).
(RH side shown)
4. After proper tracking has been achieved, hold
the pivot bolt in position with a 1/4” hex wrench,
and then torque the eccentric pivot nut (A) to
specication – 8 ft-lbs. (11 Nm).
5. Install the control panel cover, then torque the
retaining bolt to specication – 4.5 ft-lbs. (6 Nm).
6. Verify proper drive system function.
A

Toro titan zx Specifications

General

Brand	Toro
Model	titan zx
Category	Lawn Mower
Language	English