92
Setting up your TV
Setting the sleep timer
To playback DivX HD content:
v To play in fast reverse or fast forward directions, press the
or button during playback. Each time you press the or
button, the playback speed will change.
v If the content contains no chapter, this TV generates original
chapter point in 10% increments for 10 chapters in total, that
are accessible by using the Number buttons on the remote
control.
During playback, press the button to skip to the beginning of the
next chapter.
When the button is pressed twice in succession, it will repeat
two times of above.
If the buttonispressedatthelastchapter,theconrmation
message will appear.
If Yes is selected, playback will skip to the beginning of the next
content.
Press the button to skip to the beginning of the current chapter.
When the button is pressed twice in succession, it will skip to
the beginning of the previous chapter. If the button is pressed
twicecontinuouslyattherstchapter,playbackofthecurrent
contentwillstopandtheconrmationmessagewillappear.IfYesis
selected, playback will skip to the beginning of the previous
content.
Setting the sleep timer
You can set the sleep timer to turn off the TV after a set length of
time (maximum of 12 hours).
To set the sleep timer using the remote control:
1 Press the SLEEP button on the remote control to set the length
of time the TV remains on until the TV turns off.
2 Repeatedly press the SLEEP button to increase the time in
10-minute increments, or press the ▲/▼(arrow)buttonsto
increase or decrease the time in 10-minute increments, to a
maximum of 12 hours.
To set the sleep timer using the on-screen menus:
1 In Timers menu, highlight Sleep Timer, and then press the
OK button.
To Next Page
Loading...
Need help?
General