- 36 -
2.5 Installation under Windows XP/Server2003 (USB with Plug
& Play enabled)
1. Turn on the PC.
Note: Log on as the user with administrative privilege.
2. Turn on the printer, and connect it to the PC with a USB cable.
3. “USB DEVICE” is detected, and the “USB Print Support” is automatically installed.
4. After a while, new devices are detected.
New device names
B-SA4G, B-SA4G-CN, B-SA4T, B-SA4T-CN, B-SX4, B-SX4-CN, B-SX5, B-SX5-CN, B-SX6T-R,
B-SX8T-R, B-852-R, B-452-R, B-462-R, B-EX4T1-G, B-EX4T1-T, B-EX4T2-G, B-EX4T2-T,
B-EX4T2-H, B-EP2DL-G, B-EP4DL-G, B-EV4-G, B-EV4-T, B-SV4, B-FV4-G, B-FV4-T,B-FP3D,
B-EX6T1-G, B-EX6T1-T, B-EX6T3-G, B-EX6T3-T,B-EX4T3-H
5. When the “Found New Hardware Wizard” is
displayed, select “Install from a list or specific
location [Advanced]” and click the [Next] button.
6. Select the “Search for the best driver in these
locations”, check the “Include this location in the
search” checkbox, and click the [Browse] button.
Specify the folder (C:\TEC_DRV) created in
Section 2.1, and click the [Next] button.
To Next Page
Loading...
Need help?
General