- 69 -
Supply Options
Allows setting the printing energy for each of the “Direct thermal” and “Thermal transfer”. When “Use
Current Print Setting” is selected, the printer operates according to the currently selected setting.
Selection of “Direct thermal” or “Thermal transfer” depends on which is selected for the “Print Method“ on the
Stock page.
Ribbon Adjustments
When the thermal transfer method is selected, setting the conditions related to the ribbon is allowed.
( 3.4.2 Ribbon Adjustments.)
Multiple Part Print Area Settings
Enables setting the duplicate print area on double-layer thermal paper. This feature is available only to the
B-419 and B-EV4 (203 dpi). For the B-EV4 (203 dpi), “Variable Speed A” or “Variable Speed B” specified for
the “Print Speed” on the Stock page is reflected in the printer behavior.
3.4.1 Multiple Part Print Area Settings (B-EV4 (203 dpi) only)
Clicking the “Multiple Part Print Area Settings” button on the Options page enables setting the duplicate print area
properties for the double-layer thermal paper.
Multiple Part Print Area
When the “Set” checkbox is checked, you can specify the details of the “Multiple Part Print Area”.
The “Multiple Part Print Area” is the area where the printer prints both sheets of the double-layered thermal
paper at the same time by applying the higher print energy.
When not checked, the printer operates according to its current settings.
Multiple Part Print Area
Enables setting the “Multiple Part Print Area Offset (a)” (X-coordinate of the multiple part print area start
position) and “Multiple Part Print Area Length (b)”. The print on the specified area will become darker than
the normal print areas.
• Multiple Part Print Area Offset: 0.0mm to 390.0 mm
• Multiple Part Print Area Length: 0.0mm to 390.0 mm
To Next Page
Loading...
Need help?
General