- 45 -
2.10 Uninstalling the Printer Driver
2.10.1 To delete the printer drivers except for V6.5 Build75 and V6.5 Build77
In the following cases, be sure to uninstall the printer driver using the procedure below.
When the same version is installed again.
When an older version has been already installed.
When the installation is canceled on the way or when the [No] is selected at a confirmation of the digital
signature.
When the printer driver cannot be installed for some reason.
Notes: 1. When installing the printer driver with Plug & Play enabled, turn OFF the printer first.
2 When the printer driver is deleted, the information of the registered stocks and bar codes are also deleted.
This information can be saved in a file beforehand by using the export function, and restored by using the
import function after re-installation of the printer driver.
In the case of deleting the printer drivers except for V7.4 M-1
Before deleting the printer driver except for V7.4.1 M-5, follow the procedure described in Section 2.1
Preparation for Installation. Doing this causes the previously installed printer driver to be updated and
creates the shortcut of the Driver Wizard in the TPCL Printer Driver of TOSHIBA TEC folder.
However, it is not possible to update the printer driver which is older than V6.9.3 M-0. For such versions, first
delete “C:\TEC_DRV” folder, then conduct the Preparation for Installation. When the preparation is completed,
the shortcut of the “Driver Wizard” is created in the TPCL Printer Driver folder.
In the case of deleting the printer driver of “To print on the shared printer (2)”
Before deleting the printer driver, delete the printer icon that was created when the shared printer was installed.
Uninstalling the printer driver
1. Select the “Start”, “All programs”, “TOSHIBA
TEC”, “TPCL Printer Driver”, and “Driver Wizard”.
Note: Log on as the user with administrative privilege.
Exit the all Windows applications before
performing the above operation. Confirm that
there is no print job in the spooler, then close the
spooler and the printer folder.
In the case of Windows Vista/Server 2008 / 7 /
Server2008R2 / 8 / Server2012 / Server2012R2
/ 10, the User Account Control screen may
appear. In that case, click the [Allow].
To Next Page
Loading...
Need help?
General