- 44 -
2.9 Installation under Windows Vista / Server2008 / 7 /
Server2008R2 / 8 / Server2012 / Server2012R2 / 10 (Parallel
Interface with Plug & Play Enabled)
Note: If an undefined device is created after installation of the printer driver, follow the procedure described in the
section If plug-and-play installation fails under Windows
Vista/Server2008/7/Server2008R2/8/Server2012/Server2012R2/10.
1. Connect the printer to the PC with a parallel interface cable.
2. Turn on the printer.
3. Set the printer parameters in the system mode.
B-SX4 Series and B-SX5 Series
CENTRO. MODE → ECP
PLUG & PLAY→ ON
B-SA4 Series, B-852-R, B-452-R, B-SX6T (305 dpi), B-SX8T (305 dpi), B-EX4 Series, B-EX6 Series
and B-462-R
PLUG & PLAY → ON
Note: For the parameter setting procedure, refer to Section 6.2 Parameter Setting on the Printer.
4. Turn on the PC.
Note: Log on as the user with administrative privilege.
5. After the system is started, the installation of the device driver software is automatically started.
6. After a while, the installation of the printer driver is completed.
7. When the installation is completed, a new printer icon is added to the Printer folder.
To Next Page
Loading...
Need help?
General