54
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
3. SEATBACK ANGLE ADJUSTING
SWITCH
Move the control switch in the de-
sired direction.
Releasing the switch will stop the seat-
back at that position.
CAUTION
Avoid reclining the seatback any
more than needed. The seat belts pro-
vide maximum protection in a frontal
or rear collision when the driver and
the front passenger are sitting up
straight and well back in the seats. If
you are reclined, the lap belt may
slide past your hips and apply re-
straint forces directly to the abdomen
or your neck may contact the shoul-
der belt. In the event of a frontal
collision, the more the seat is re-
clined, the greater the risk of death
or serious injury.
4. SEAT LUMBER SUPPORT ADJUSTING
SWITCH
Push the switch on either side.
The amount of lumbar support will
change while the switch is pushed.
XS13209
BEFORE FOLDING FRONT
PASSENGER’S SEAT
1. Push the seat belt hanger down as
far as it will go when it is in the
raised position.
XS13160
2. Make sure the shoulder belt passes
through the hanger when folding the
front passenger’s seat.
This prevents the shoulder belt from being
damaged.
CAUTION
The seat belt must be removed from
the hanger when the seat belt is in
use.
07 04.26
—Folding front passenger’s
seat (Regular cab models)
To Next Page
Loading...
Need help?
General
