375
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
Display “995734”
Repeat the above procedure until the
entire number that you want to dial is
input.
Go back operation—
You say: “Go back”
Voice output: “Go back, the last
numbers entered have been removed.
Push the talk switch and continue
adding numbers otherwise say dial,
go back, or delete.”
Display: “995”
Repeating the above operation deletes
the last digits in reverse order of in-
put.
Delete operation—
You say: “Delete”
Voice output: “Deleted. The entire
number to dial has been deleted.
Please push the talk switch and say
the number.”
Display: “Dial by Num”
The display will return to the initial
screen that allows a number to be
input.
Cancel operation—
Do either one of the following:
z Push the on−hook switch at anytime
during the operation.
z Push the talk switch and say
“Cancel” after the beep at anytime
during the operation except while a
call in connected.
When receiving a phone call, a ring tone
is audible and the system changes into
the telephone mode.
When receiving a phone call, the display
is as follows. The display differs depend-
ing on whether or not the vehicle is in
motion.
When the vehicle is stopped:
Number, name, or “Incoming” is displayed.
When the vehicle is in motion:
“Incoming“ is displayed.
Do either one of the following:
D Pushing the off−hook switch allows you
to talk on the phone.
D Pushing the on−hook switch refuses
the call.
To adjust the ring volume, push “+” or “−”
on the steering volume controls. Volume
adjustment cannot be done using the au-
dio system.
Repeatedly pushing “−” on the steering
volume controls mutes the ring.
When receiving an international phone
call, the name of the party may not be
displayed correctly depending on the cellu-
lar phone.
07 04.26
—Receiving a phone call
To Next Page
Loading...
Need help?
General
